Heavy Duty Cast Iron Double Groove V Belt Pulley With 4.6 Inch Outer Diameter And 5/8 Inch Bore Built Tough For Series Ax A And 4L Drive Belts Ready To Rock On Shop Floors Or Weekend Projects

Double Groove Sheave Pulley For Reliable Industrial Drive
✔️ OD 4.6 inch bore 5/8 inch two groove cast iron fits 4L belt

This solid double groove sheave pulley is built to move steady power from motors straight into machine frames. You will see it holding down position on factory workbenches, packaging lines, and farm rigs where consistent traction keeps downtime low. Each listing covers one ready to bolt unit with a straight H bore match.

✅ Machined from fine grained cast iron for lasting structural strength
✅ Statically balanced design minimizes vibration during high speed rotation
✅ Handles 4L A and AX V belt sections for flexible setup routing
✅ Painted exterior finish guards against shop dust and corner rust spots

💡 How to properly size a double groove solid sheave pulley for reliable industrial belt drive upgrades?

Spotting the right match with a handy layout plan comes down to checking belt pitch depth and shaft clearance before pulling the trigger.
- Keep the rubber riding snug in both cast iron channels by dialing tension evenly
- Square the five eighth inch bore perfectly to your motor shaft to stop premature fraying
- Crank the locking hardware slowly until the hub locks hard and runs dead flat under load

✝️

2AK46H 5/8" Bore Solid Sheave Pulley with 4.6" OD Double Grooves for V-belts size 4L, A, AX, 2AK46H 5/8" (Pulley OD 4.6"- H:ID 5/8")

Outside diameter: 4.6" inch H Bore: 5/8" inch Belt section size:4L, A,AX 2 Grooves One pulley Cast Iron